For your Antminer S19, this means the control board will only boot with firmware which has a legitimate digital signature from Bitmain.

Upgrading the Firmware: Within the miner's interface, navigate towards the upgrade segment. Add the downloaded firmware file and initiate the improve system. Will not electrical power off or disconnect your miner throughout this process.

It’s vital to go to the trouble to appropriately put together and retain factors ahead of, throughout, and immediately after installation. This features making use of thermal gel for superior warmth transfer, forming air ducts for improved airflow, connecting energy materials in the correct sequence, correcting chips to circumvent overheating, and guaranteeing test fixtures meet production prerequisites.

Even though the Braiins OS improvement group is hard at work introducing support for Whatsminers and diverse control board versions on the Antminer S19 products, we’re hearing the inquiries (and albeit the frustrations) of numerous miners who would like us to release this guidance yesterday.

Preparing for Improve: Before starting the enhance, make sure your miner is steady and never overheating. Back up your present options being a precaution.

For those who have any dissatisfaction through the transaction or have beneficial ideas for us, be sure to Call us by means of this email tackle:

Set variable PSU amongst 17V and 21V. Have some new chips pre tinned Prepared for application. Just before powering the hashboard on, make sure polarity is good, normally the booster chip will burn off. Connect to the IP tackle of one's ARC Tester, readily available by pushing on the still left knob.

Disclaimer: The information presented on this web site is for informational applications only and really should not be taken as any kind of recommendation.

In order to repair the Antminer hashboard, we to start with will need to find out The situation of the destroyed chip While using the ARC Tester. In an effort to make sure precision, batchminer.com we even now have to utilize a multimeter to test the hashboard signals.

two. Insert the card reader in the OTG cable, and insert the OTG cable (or specifically insert the OTG U disk) in to the Micro USB port around the front of the miner.

Right before connecting it for the output of your Increase module, we have to take a look at the positive and adverse poles of C1314 with a multimeter.

After the schedule take a look at is Okay, You can utilize the ARC Tester to accomplish chip detection, and establish the positioning based on the test fixture exam final results.

Once the stock is low, We'll deliver the universal control board, all of the control board will probably be strictly analyzed to make sure the typical Procedure right before cargo.

Vipera also includes a big variety of other substitution areas, so if You aren't guaranteed what you'll need, talk to our Stay-chat agent for assistance.